| View previous message :: View next message |
| Author |
Message |
vonniz
Joined: 04 Apr 2009
Posts: 1
City / Country: Elst
|
 Posted: Mon Apr 13, 2009 11:00 am Post subject: battery 3 and side chain compressing |
 |
|
I just recently tried side chain compressing my kicks with the bassline and the results are awesome. The problem is, i like battery 3 and use it a lot. Now I can't seem to figure out how to side chain my compressor to listen only to a kick sample from my battery 3. At the moment, I compress the bass, and have it listen to the entire drum kit. So somehow I need to send the kick I want to listen the compressor to, trough a individual channel, so that my compressor will only trigger when the kick plays. the rest of the drumkit should be send trough different channels.
The problem is, I can't find a way in battery to send 1 or a few sounds/cells trough a different channel then the rest of my drumkit.
could someone help me out with this one please? |
|
| Back to top |
|
 |
jerinrealtime
Joined: 26 Dec 2007
Posts: 2
|
| Posted: Fri Oct 16, 2009 11:12 pm Post subject: |
|
|
make a duplicate of your battery channel, copy all midi regions to new channel, delete all midi data on new channel except kick drum, route signal of new channel to the bus channel you selected to side chain compressor. set the signal flow to bus of new channel on 'pre' so you can cut the volume of new channel but the signal still reacts with the compressor. this way you don't have 2 kick signals.
ta-daaa!
hope this helps- i'm still a novice so let me know if i'm off about anything |
|
| Back to top |
|
|
synchro
Joined: 08 Nov 2009
Posts: 3
|
| Posted: Sun Nov 08, 2009 12:26 pm Post subject: |
|
|
You don't like the built-in compressor in Battery 3? I admit it's a bit limited and not very warm. But it does compress quite well.
It would be amazing if Battery allow access to FX plug-ins from within it's own audio DSP area. |
|
| Back to top |
|
|
pratishtha
Joined: 09 Dec 2009
Posts: 1
|
| Posted: Wed Dec 09, 2009 7:10 am Post subject: |
|
|
| the bus channel you selected to side chain compressor. set the signal flow to bus of new channel on 'pre' so you can cut the volume of new channel but the signal still reacts with the compressor. this way you don't have 2 kick signals. |
|
| Back to top |
|
|
tomzbiz
Joined: 04 Dec 2006
Posts: 1
|
| Posted: Sun May 16, 2010 3:43 am Post subject: |
|
|
| what about routing the kick drum to an individual output and using that output to trigger the sidechain? battery 3 is a multi out plug in. |
|
| Back to top |
|
|
|
|
You cannot post new messages in this forum
You cannot reply to messages in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
Download Sounds & Samples
